Table of Contents
What causes no spark to distributor?
Loss of spark is caused by anything that prevents coil voltage from jumping the electrode gap at the end of the spark plug. This includes worn, fouled or damaged spark plugs, bad plug wires or a cracked distributor cap.
What if my ignition coil has power but no spark?
There are a few reasons for no spark, new coil pack could be defective, crank sensor, ignition module or bad wire in primary circuit, faulty ECM/PCM. You may have to have a good technician have a look, diagnose and estimate repair.
How do you test a distributor for spark?
Pull the coil wire from the distributor and hold it near a ground.Again, have your assistant crank the engine and look for spark from the coil lead. If you have spark, you likely have a problem with your distributor rotor or cap, so you may want to replace them.
What sends spark to the distributor?
The rotor spins because it’s connected directly to the shaft of the distributor. As the rotor spins, it makes contact with a number of points (4, 6, 8 or 12 depending on how many cylinders your engine has) and sends the spark through that point to the plug wire on the other end.
Why is my distributor not getting spark?
If the ignition control module has failed altogether, it’ll create a weak spark, and the car won’t start. Check to see if the switch and terminals are free from rust and replace any damaged or broken spark plugs wires as necessary. Alternatively, it could be a bad ignition module.
What gives spark to the distributor?
The electronic ignition pickup coil sits inside the distributor and triggers the ignition system to produce a spark. As such, if there’s an issue with the pickup, it can make starting your car difficult.
Why do I have power to my coil but no spark?
There are a few reasons for no spark, new coil pack could be defective, crank sensor, ignition module or bad wire in primary circuit, faulty ECM/PCM. You may have to have a good technician have a look, diagnose and estimate repair.
How can I fix no spark?
If you do not see a spark, there is an ignition problem. Remove a plug wire and insert an old spark plug or a spark plug tester into the end of the wire (the plug boot). Place the spark plug on a metal surface on the engine, or ground the spark plug tester to the engine. Then crank the engine to check for a spark.
What do I do if I’m not getting spark?
There are a few reasons for no spark, new coil pack could be defective, crank sensor, ignition module or bad wire in primary circuit, faulty ECM/PCM. You may have to have a good technician have a look, diagnose and estimate repair.
What stops a coil from firing?
If you do not see a spark, there is an ignition problem. Remove a plug wire and insert an old spark plug or a spark plug tester into the end of the wire (the plug boot). Place the spark plug on a metal surface on the engine, or ground the spark plug tester to the engine. Then crank the engine to check for a spark.
Will a bad ignition switch cause no spark?
A bad coil or a cracked distributor cap can stop the spark plugs from firing.
